| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Replacing nut on Ibanez Wizard III neck http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10137&t=44140 |
Page 1 of 1 |
| Author: | raorn [ Fri Sep 12, 2014 7:43 am ] |
| Post subject: | Replacing nut on Ibanez Wizard III neck |
Greetings, luthiers. I am about to replace nut on Ibanez XP300FX with 3pc Wizard III neck. Bought matching Graphtech Black Tusq XL 43x6mm nut, googled video instruction http://www.youtube.com/watch?v=tmUAuRs3Og0. Looks like it's not a Rocket Science - remove old nut, sand new nut, check strings height, glue new nut. Are there any caveats? Any common mistakes? Is there anything Wizard-specific or Tusq-specific I should know before I start? Is it OK to use PVA glue, or I should use Epoxy?.. |
|
| Author: | Cal Maier [ Fri Sep 12, 2014 9:33 am ] |
| Post subject: | Re: Replacing nut on Ibanez Wizard III neck |
PVA is fine, do NOT use epoxy. C~ |
|
| Author: | dzsmith [ Fri Sep 12, 2014 5:36 pm ] |
| Post subject: | Re: Replacing nut on Ibanez Wizard III neck |
Cal Maier wrote: PVA is fine, do NOT use epoxy. C~ And only a tad on the bottom of the nut. I use two small dabs. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|