25" on that scale length
| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| PRS Custom 24 measurements http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10123&t=28023 |
Page 1 of 1 |
| Author: | jimmysux [ Wed Jun 30, 2010 1:50 pm ] |
| Post subject: | PRS Custom 24 measurements |
Been taking measurements of my CU 24 with a trem and thought I would share, just to, and just to see if anyone thought I was off on anything. End Of Headstock To Nut = 6 1/8" From Nut To Bridge Saddle = 25 1/2" Width Of Body At Largest Point = 13" Depth Of Neck Joint = 1 5/16" Length Of Body At Longest Point = 17 3/4" Depth Of Neck without fingerboard = 3/4" (mine is a wide thin) Body Thickness = 1 7/8" (Mahogany Back is 1 1/8" leaving maple cap thickness at 3/4") Neck Angle = 3.5 degrees Headstock Angle = 13 degrees |
|
| Author: | jimmysux [ Wed Jun 30, 2010 2:18 pm ] |
| Post subject: | Re: PRS Custom 24 measurements |
| 25" on that scale length
|
|
| Author: | Gabby Losch [ Wed Jun 30, 2010 3:32 pm ] |
| Post subject: | Re: PRS Custom 24 measurements |
Very timely post for me. I've been running back and forth from the garage to measure things on my PRS Custom 24 for reference during my current build. Nice to have everything written out in one place. Thanks! |
|
| Author: | jimmysux [ Sat Jul 03, 2010 10:51 am ] |
| Post subject: | Re: PRS Custom 24 measurements |
Mine is a 2008 custom 24. Clocked in right at 3.5 for me. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|