| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| M.O.P fingerboard inaly sanding http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10123&t=26689 |
Page 1 of 1 |
| Author: | GrumpyGinger [ Thu Mar 25, 2010 2:59 am ] |
| Post subject: | M.O.P fingerboard inaly sanding |
finished drawing sharktooth inlays & sorted through pieces to use and come across one piece that catches the light very well, my only prblem with this is after i put it into the fingerboard i have to sand it. knowing that i may loose the pattern. is there anyway of getting around this? will be inlaying on a 12" rad with 1.5mm thick MOP. if i can get a pic up of the piece sometime today i will. thanks |
|
| Author: | Bob Garrish [ Thu Mar 25, 2010 8:51 pm ] |
| Post subject: | Re: M.O.P fingerboard inaly sanding |
Outside of using Gravlam, or slicing the piece up into multiple slivers and reconstituting it into a radiused piece, you pretty much have to hope for the best when sanding a bunch off of a piece of shell. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|