| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Question about installing fine purfling with small cutter http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10123&t=21876 |
Page 1 of 1 |
| Author: | wm17959 [ Fri Apr 10, 2009 8:44 am ] |
| Post subject: | Question about installing fine purfling with small cutter |
I have never done this, but I’m going to be installing the PFL12 purfling (from LMI), which is .060” wide and I’d like to buy a SCCBB .055” spiral cutter to do it. I plan on using a Dremel tool with a base and cutting about 1/16” deep into hardwood, and I’m worried that this small cutter will easily break off if it heats up (it costs about $20). Does anyone have experience with this or any suggestions for me? |
|
| Author: | bluescreek [ Sun Apr 12, 2009 3:38 pm ] |
| Post subject: | Re: Question about installing fine purfling with small cutter |
Bochett quality tools will get you bits that are very affordable. |
|
| Author: | Bob Garrish [ Sun Apr 12, 2009 3:47 pm ] |
| Post subject: | Re: Question about installing fine purfling with small cutter |
Here's the link for that company: http://bqtool.com The prices are decent. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|