Official Luthiers Forum!
http://mowrystrings.luthiersforum.com/forum/

Halo dots with Elevate dot doctor
http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10117&t=55371		 Page 1 of 1
Author:  bcombs510 [ Sat Nov 26, 2022 5:15 pm ]
Post subject:  Halo dots with Elevate dot doctor
Hello,

Here are some details about the bits and material I use with the Elevate Lutherie Dot Doctor product. I have tried a lot of different materials but these produce the best results for me.

The part numbers for each item are listed. I use a 3/32 Fuller brad point bit. The aluminum tube is from Amazon or you can order direct. The white dot material is 1/16” from StewMac. I repurposed an old zona saw by taking the blade out making it flush cut. It doesn’t take much life in the blade to cut the aluminum and plastic.

Hope that helps someone trying to do halo dots with this tool.

Brad

Image


Image

Image

Image

Image

Image

Image

Image

Image

Image


Sent from my iPhone using Tapatalk Pro
Author:  SteveSmith [ Sat Nov 26, 2022 7:12 pm ]
Post subject:  Re: Halo dots with Elevate dot doctor
Dots look good, the metal ring is a nice touch.


Steve
Author:  joshnothing [ Sat Nov 26, 2022 9:29 pm ]
Post subject:  Re: Halo dots with Elevate dot doctor
Nice crisp look. Great work.


Sent from my iPhone using Tapatalk
Author:  dzsmith [ Sun Nov 27, 2022 6:15 pm ]
Post subject:  Re: Halo dots with Elevate dot doctor
Awesome Brad!
Thanks for sharing!
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/