Mdf may not be air tight enough for use as a vacuum table.
| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Making Vacuum Table http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10106&t=42504 |
Page 1 of 1 |
| Author: | dholzric [ Tue Jan 21, 2014 10:34 am ] |
| Post subject: | Making Vacuum Table |
Is there a minimum volume necessary for the internal volume on a vacuum table? I was looking at the one that Donek has on their web site but I don't want to take up very much of my z axis for the vacuum table. http://www.youtube.com/watch?v=fOrkvPF0pro I was thinking about creating it with 3 layers of 1/2" mdf with the middle one cutout below the holes in the top sheet. |
|
| Author: | Chris Pile [ Tue Jan 21, 2014 12:10 pm ] |
| Post subject: | Re: Making Vacuum Table |
No help here, Danny! Had to say HI! |
|
| Author: | Andy Birko [ Tue Jan 21, 2014 7:19 pm ] |
| Post subject: | Re: Making Vacuum Table |
Here's my vacuum table: viewtopic.php?f=10106&t=38998&p=513909&hilit=vacuum+table#p513909 |
|
| Author: | Durero [ Wed Jan 22, 2014 12:40 pm ] |
| Post subject: | Re: Making Vacuum Table |
Mdf may not be air tight enough for use as a vacuum table.
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|