| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| VisualMill 2014 http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10106&t=41790 |
Page 1 of 1 |
| Author: | Sheldon Dingwall [ Tue Oct 29, 2013 10:20 am ] |
| Post subject: | VisualMill 2014 |
I was impressed enough with the improvements to VisualMill 2012 that I took the release of 2014 more seriously than I normally would. This is looking pretty good. HSM tool paths, improved spiral pocketing (which in now useful for non-circular shapes) and triangular bridges are what really catch my attention. |
|
| Author: | Andy Birko [ Tue Oct 29, 2013 4:10 pm ] |
| Post subject: | Re: VisualMill 2014 |
I've been eyeballing it as well though I shudder to think what the upgrade price will be. It seems that they've addressed a number of issues that have been brought up in the forums. I run VM for SolidWorks and I hope that they include some of the stuff that's been brought up in there as well - namely being able to use it in assemblies. |
|
| Author: | Sheldon Dingwall [ Thu Oct 31, 2013 10:18 am ] |
| Post subject: | Re: VisualMill 2014 |
I watched the webinar yesterday. They mentioned that the upgrades will be introduced into the SW version soon. I don't know what assemblies are but the Standard version upgrade cost is not too bad. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|