| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| 8 String Tune-o-Matic Bridge machining needed http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10106&t=36443 |
Page 1 of 1 |
| Author: | hugh.evans [ Thu May 10, 2012 2:28 pm ] |
| Post subject: | 8 String Tune-o-Matic Bridge machining needed |
Looking for someone with a CNC mill to produce some 8 string tune-o-matic bridges (probably from steel.) I have the design nearly ready to go in SoldWorks, but I'm still ~2 months out from putting CNC into my shop. This is an unfilled market niche, and the possibility exists to do large enough production runs to offset tooling costs and make a bit of a profit. Please PM if interested. Thanks! |
|
| Author: | Ken McKay [ Sat Jun 02, 2012 7:20 pm ] |
| Post subject: | Re: 8 String Tune-o-Matic Bridge machining needed |
Someone at the www.mylespaul.com forum had made a nice one for Dan Neifer. Look in the Luthiers forum. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|