What Arie said.
As an aside, it really doesn't matter. The shafts on turbine spindles are concentric with their collets and the air line is more than enough to stop them from spinning. It's really not going to notice 1/2 RPM of drift in 65,000
| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Holding an air spindle in a Fadal? http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10106&t=35217 |
Page 1 of 1 |
| Author: | Sheldon Dingwall [ Wed Feb 01, 2012 9:10 am ] |
| Post subject: | Holding an air spindle in a Fadal? |
I noticed Taylor doesn't use an alignment pin to keep their air spindles from free spinning. Does the spindle resist turning if 0 RPM is programmed? It doesn't seem right to just let the air line keep the tool from rotating. |
|
| Author: | arie [ Fri Feb 24, 2012 12:37 pm ] |
| Post subject: | Re: Holding an air spindle in a Fadal? |
spindle lock/orient -M19 |
|
| Author: | Bob Garrish [ Fri Feb 24, 2012 5:11 pm ] |
| Post subject: | Re: Holding an air spindle in a Fadal? |
What Arie said. As an aside, it really doesn't matter. The shafts on turbine spindles are concentric with their collets and the air line is more than enough to stop them from spinning. It's really not going to notice 1/2 RPM of drift in 65,000
|
|
| Author: | Sheldon Dingwall [ Tue Feb 28, 2012 6:54 pm ] |
| Post subject: | Re: Holding an air spindle in a Fadal? |
Thanks guys. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|