| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Nominal neck pocket widths. http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10106&t=35201 |
Page 1 of 1 |
| Author: | cactus [ Tue Jan 31, 2012 1:00 am ] |
| Post subject: | Nominal neck pocket widths. |
Newbie. Just registered with a community furniture course, have access to their ShopBot 4'x4' so I'm scheming.. When I'm designing a neck and neck pocket (tight fit), should the neck width be the same as the pocket width? Thanks. |
|
| Author: | Mike Kroening [ Tue Jan 31, 2012 1:41 am ] |
| Post subject: | Re: Nominal neck pocket widths. |
My first thought is no. The reason behind this is, each machine is different. Whether it be backlash, or endmill differences, flex, or wood types. Usually I will try a scrap piece with about 0.005 difference in cut and go from there. Some woods and machines will be tighter and some looser, but its a good place to start. Just my experience so far. My machine with maple is usually 0.004 offset from one to the other. In mahogany about about 0.002. These are usually a hard press fit, and good glue squeeze out, not requiring clamping other than to hold something in its place. So have fun and practice before committing. MK |
|
| Author: | Parser [ Tue Jan 31, 2012 8:13 pm ] |
| Post subject: | Re: Nominal neck pocket widths. |
I'd recommend cutting the neck slightly oversize and then hand fitting it to the pocket. Bodies warp, wood grows, stuff changes....nothing wrong with taking that last .005" by hand...! Trev |
|
| Author: | Stuart Gort [ Tue Jan 31, 2012 9:15 pm ] |
| Post subject: | Re: Nominal neck pocket widths. |
I draw the model with the fits net....meaning the neck tongue and the body pocket will both have the same geometery. That keeps things simple and less confusing for me. I highly recommend you don't try to establish your fits in your models...but rather...in your cam program files. When I cut the necks I always cut the tongues net to the model...no over or undercut. So...if I make 10 necks I cut them all without measuring the tongue width or length other than to make sure I've not made a gross error. When it comes time to cut the body pocket I mate each neck to each body and I cut each body pocket to fit THAT neck...and that neck only. Usually it's going to end up being an overcut of .003" to .005" but I sneak up to each fit by making the first cut an undercut...and then make progressive cuts bigger and bigger....in increments of .0005"....until I get a nice snug fit. When I have a nice dry fit I glue it immediately. |
|
| Author: | cactus [ Wed Feb 01, 2012 3:01 pm ] |
| Post subject: | Re: Nominal neck pocket widths. |
Thanks gang!! Can't wait to dive in.. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|