Official Luthiers Forum!
http://mowrystrings.luthiersforum.com/forum/

Looking for Drive Belts
http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10106&t=23738		 Page 1 of 1
Author:  Shane Neifer [ Tue Sep 08, 2009 4:11 pm ]
Post subject:  Looking for Drive Belts
Dudes!

So I have started playing my CNC machine and as a result have opened everything up and I really need to replace the belts! Once that is done the machine should be running SMMMOOOOOOTTHHHHH! Anyway, I found and ordered all of the "XL 037" belts for the servos and pulleys but I can't seem to find the main drive belt for the "X" axis. Any idea where a guy can look for these belts? They are about 1 inch wide and 65 inches long and are timing belts ( duh ).

Thanks in advance...I have a few feelers out but should always remember that this is the first place to ask!

Thanks

Shane
Author:  devincox [ Tue Sep 08, 2009 5:31 pm ]
Post subject:  Re: Looking for Drive Belts
These guys have a pretty good selection.
https://sdp-si.com/eStore/

Devin
Author:  Shane Neifer [ Tue Sep 08, 2009 5:49 pm ]
Post subject:  Re: Looking for Drive Belts
devincox wrote:
These guys have a pretty good selection.
https://sdp-si.com/eStore/

Devin


Thanks Devon! They were so close! I will actually call them tomorrow (I am on the west coast so they are closed now). They don't list my belt which I believe is a .200 XL pitch, 60 grooves per inch but is 1 inch wide.

Thanks
Shane
Author:  devincox [ Tue Sep 08, 2009 5:57 pm ]
Post subject:  Re: Looking for Drive Belts
No problem. I was actually looking for some belts for my new cnc and then saw this post.
I hope they can help.

Devin
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/