Official Luthiers Forum!
http://mowrystrings.luthiersforum.com/forum/

Source for vacuum gasket
http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10106&t=16196		 Page 1 of 1
Author:  npalen [ Sun Mar 02, 2008 8:47 am ]
Post subject:  Source for vacuum gasket
Hello guys
Wondering if anyone can recommend a source for 1/4" diameter closed cell foam for a vacuum gasket?
I've been using soft plastic tubing set in a 1/4" round bottom groove but thinking that foam might work better.
Thanks in advance for any suggestions.
Nelson
Author:  Jay [ Sun Mar 02, 2008 5:06 pm ]
Post subject:  Re: Source for vacuum gasket
Try this company I used them when I had a CNC and they had the best stuff. [:Y:]
http://www.allstaradhesives.com/
Jay
Author:  Don Williams [ Sun Mar 02, 2008 5:33 pm ]
Post subject:  Re: Source for vacuum gasket
Yep! That's the place. Not far from me either.
Author:  Guest [ Sun Mar 02, 2008 6:16 pm ]
Post subject:  Re: Source for vacuum gasket
Thanks, guys. Much appreciated.
Nelson
Author:  npalen [ Wed Mar 05, 2008 4:23 pm ]
Post subject:  Re: Source for vacuum gasket
Had a great response from Mike Murphy at Allstar.
Very helpful! See their URL above.
Nelson
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/