Official Luthiers Forum!
http://mowrystrings.luthiersforum.com/forum/

WAY Cool CNC Electronics Rig..
http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10106&t=13388		 Page 1 of 1
Author:  Don Williams [ Sat Aug 25, 2007 12:40 pm ]
Post subject: 
Check it out! He's even got an arcade joystick and buttons in there. It's all tricked out!





Author:  Sprockett [ Sat Aug 25, 2007 1:38 pm ]
Post subject: 
Dad...

When can *I* play on the CNC machine!!!.....

Hehehehehe...

That's pretty cool, they don't stay that clean long :P...

I have an flight sim joystick on mine, but I moved to a portable keyboard, I've been looking at this lately:

Shuttle Pro

I like the T tracks running length wise, mine run the other way, it works but can be a pain at times...

Very nice machine he has there...

-Paul-
Author:  Don Williams [ Sat Aug 25, 2007 9:43 pm ]
Post subject: 
I'm going to do something similar with all the buttons and joystick, but it will mount underneath the unit and pull out on a set of drawer glides.
( yeah I know, I like using those )

I will probably house the Gecko stuff seperately in a box with a fan or two, and some good filters to keep the dust out.

I'm probably only going to have T-tracks on one half of my rig. It will have the gantry running the long direction, so it will be wide rather than deep. I plan to have a space in the front on one side where I can mount a body for doing end grafts, and also to mount a neck for cutting dovetails and tenons. Most of the jigs and such will be used on the other half of the unit.
Author:  Parser [ Mon Aug 27, 2007 4:03 am ]
Post subject: 
That's a cool setup..! Can you play old school nintendo on that thing or what?

The Z axis looks a little short to me though...no way I could fit a duck decoy under there!   
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/