Official Luthiers Forum!
http://mowrystrings.luthiersforum.com/forum/

New Round Neck Reso
http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10104&t=24696		 Page 1 of 1
Author:  Ron Belanger [ Fri Nov 20, 2009 6:43 pm ]
Post subject:  New Round Neck Reso
New round neck reso delivered last night. Customer very happy.

Solid mahogany back, sides, top and neck
ebony fingerboard and headstock veneer
white pearl inlaid initials
Paul beard cone, spider and hardware
Gotoh open back tuners
K & K pickup

there seemed to be a lot of little things that needed tweaking on this one during final assembly and set up. But once done it sounded sweet!
Author:  Loren Schulte [ Sat Nov 21, 2009 6:13 pm ]
Post subject:  Re: New Round Neck Reso
And I'll bet it sounds as good as it looks. Beautiful job, Ron!
Author:  Mike Dotson [ Mon Nov 23, 2009 11:04 pm ]
Post subject:  Re: New Round Neck Reso
Very Nice!
Author:  Ron Belanger [ Tue Dec 01, 2009 12:12 pm ]
Post subject:  Re: New Round Neck Reso
Thanks for the comments, I just finished another with no cutaway and it will be shipped out to Texas today. :)
Author:  Chuck [ Mon May 03, 2010 2:58 am ]
Post subject:  Re: New Round Neck Reso
That is a great looking and I bet great sounding resonator.
Chuck
Author:  Chris Paulick [ Sat Dec 25, 2010 7:11 pm ]
Post subject:  Re: New Round Neck Reso
Nice job!
Author:  kenjeffs [ Mon Dec 27, 2010 10:58 pm ]
Post subject:  New Round Neck Reso
Looks very nice. I just jointed the top and bottom plates on my first resonator today. Solid mahogany, square neck
Author:  alan stassforth [ Thu Jan 20, 2011 12:28 am ]
Post subject:  Re: New Round Neck Reso
verhoevenc wrote:
AAAAAHHHHHH!!!!! I wanna have the time to build a round neck reso SO bad!!!!
Chris

So, why not do it?
Better yet, make a squareneck!
You could use that nice white ebony job you made.
Or, did you already ruin it and make a "regular" git neck out of it?
Ha!
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/