Sorry i didn't reply sooner, Ive been gone all day today.
I have bent the sides, and installed the end block. The neck block is cut and ready to be glued in, its over sized length wise, as that is how I make them. I go flush with the top and sand them down to the final height from the bottom side with the bowl sander.
As for me, I may have bitten off more than I can chew. Id be happy to send the rims on to the next stop for profiling and kerfing.
I have had plenty of time, but like so many other things this has fallen to the back burner just to many times. My limited time that I get in the shop has been spent on clients guitars, one if which I should have had done in December, so Ive been working against that time line as well.
NOW, I say this NOT as an excuse, I have had plenty of time, I just simply have not gotten it done.
Anybody game to profile and kerf this beast?