| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Need Dremel bit 1/16" cutter http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10102&t=13882 |
Page 1 of 1 |
| Author: | Terry Stowell [ Wed Oct 03, 2007 11:24 am ] |
| Post subject: | |
Hi all, I'm in need to borrow or buy a Dremel bit with a 1/16" cutter for a rosette I'm working on. It is a sapelle inlaid into a Lutz top. I just think it needs purfling to clean it up. Does anyone have one they can spare? I can swap some headplate woods or something.... I'm working on my brother's 50th birthday gift. |
|
| Author: | Rod True [ Wed Oct 03, 2007 11:27 am ] |
| Post subject: | |
Terry, I don't have you for you, you can buy them from Stew-Mac (you may know this already though) |
|
| Author: | Pwoolson [ Wed Oct 03, 2007 11:30 am ] |
| Post subject: | |
Terry, try this: 1/16" cutter Or look around J&L for something you like better. Good source for this kind of stuff. |
|
| Author: | BobK [ Wed Oct 03, 2007 12:54 pm ] |
| Post subject: | |
I'm a huge fan of these bits from Micromark. fiah tail router bits I've used them in a dremel for cutting brace pockets in linings, in a drill press for cutting saddle slots in ebony and in a router for rosettes. No tearout - even in the usual problem spots when cutting rosette channels. Bob K |
|
| Author: | James W B [ Wed Oct 03, 2007 1:01 pm ] |
| Post subject: | |
Todd do those give a clean cut in spruce for Rosettes? James |
|
| Author: | vachterm [ Wed Oct 03, 2007 7:21 pm ] |
| Post subject: | |
Terry, i think i have about 50 or so bits of that size. but ill only be back home in about 1 week. if the waiting for my arrival home and the waiting for the intl. shipping is fine with you, then let me know. Udi. |
|
| Author: | Terry Stowell [ Fri Oct 05, 2007 5:00 am ] |
| Post subject: | |
Thanks guys! Great tips for all! I appreciate that. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|