Official Luthiers Forum!
http://mowrystrings.luthiersforum.com/forum/

Tap Tones on My Carp/Adi top
http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10102&t=13722
Page 1 of 1

Author:  BlackHeart [ Thu Sep 20, 2007 2:31 pm ]
Post subject: 

As there have been some interest in this topic, I thought I would post my progress on brace caving. These are before and after on my practice top. The top has a low growl to it, that I would hope will carry over to my next top for the guitar. I get a few real nice long resonations out of this top on the MP3 you can hear. The mic picks it up fairly good, this is with no effects. I do look forward to bracing this week end! Carving it next week after the HHG sets!


I have one full, minus the neck, screwed up guitar set parts for various reasons, for all you mistake buffs out there.



Taptone uncarved
http://www.supload.com/listen?s=XKUHVV0LP7B0



Taptone carved
http://www.supload.com/listen?s=SB3N5BFWAIC5


 


 


 


Author:  Howard Klepper [ Fri Sep 21, 2007 7:00 am ]
Post subject: 

What is a Carp/Adi top? Made from two different woods?

Author:  BlackHeart [ Fri Sep 21, 2007 10:14 am ]
Post subject: 

[QUOTE=Howard Klepper]What is a Carp/Adi top? Made from two different woods?[/QUOTE]


 


Its a carpathian spruce top, and adirondak bracing.


Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/