So its taken me a few months to get to the point where I got a chance to try out my new Kett Endgraph jig.
I knew the concept was good, but how did it really work? Was it as easy as 1-2-3? Guess what!
Below is a short photo story line of how I used it.
I know for a lot of you guys/gals out there cutting the end graph is easy, for me its a PITA! last time I did one it took me the better of 3 hrs to get perfect.
Here you see the .250 bit, made for a single pass - no purflings, Mark included 3 different guides for no purflings, 2 lines and 3 lines.
Here im inserting the router into the guide (ive actually already cut it, but I wanted this pic to explain.
Making the pass
After one pass
Rough channel cut.
Quick pass with sandpaper.
The .250 binding falls right in, snuggly. flood with CA - done! Total time including set up, about 15 minutes.
