| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Titebond II or Titebond III http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10101&t=56628 |
Page 1 of 1 |
| Author: | Bill Higgs [ Sat Jun 08, 2024 10:26 pm ] |
| Post subject: | Titebond II or Titebond III |
Gluing some purfling to some binding before bending them in a hot sidebending jig. Which one (Titebond II or Titebond III) takes the heat bending better. I've done this before, but I can't remember which one I used. |
|
| Author: | Jim Watts [ Sat Jun 08, 2024 10:46 pm ] |
| Post subject: | Re: Titebond II or Titebond III |
Titebond III. Works great for this application. |
|
| Author: | SteveSmith [ Sun Jun 09, 2024 7:25 am ] |
| Post subject: | Re: Titebond II or Titebond III |
Jim Watts wrote: Titebond III. Works great for this application. Same here |
|
| Author: | Duct Tape [ Sun Jun 09, 2024 1:03 pm ] |
| Post subject: | Re: Titebond II or Titebond III |
Second try, first post disappeared into cyber world. I laughed when I saw this thread. Just bent Ebony bindings with side red purfling on the Fox bender that I glued up last night. With TB3. Went great. |
|
| Author: | meddlingfool [ Sun Jun 09, 2024 7:02 pm ] |
| Post subject: | Re: Titebond II or Titebond III |
TB3 too here… |
|
| Author: | Terence Kennedy [ Sun Jun 09, 2024 9:29 pm ] |
| Post subject: | Re: Titebond II or Titebond III |
Here also. |
|
| Author: | maarten_van_guyse [ Wed Jun 12, 2024 1:47 am ] |
| Post subject: | Re: Titebond II or Titebond III |
I can't comment on the difference between TB II or III, but I use HHG for glueing up bindings and purfling. HHG will only release with heat AND moisture, so it works great for this application too. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|