| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Oval Sound Hole and rosette http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10101&t=54634 |
Page 1 of 1 |
| Author: | Mike OMelia [ Sat Dec 18, 2021 3:09 pm ] |
| Post subject: | Oval Sound Hole and rosette |
Anyone here done this? How? My top is curved (mandolin). Mike |
|
| Author: | Darrel Friesen [ Sat Dec 18, 2021 4:19 pm ] |
| Post subject: | Re: Oval Sound Hole and rosette |
I've done two oval hole archtops but chickened out on the rosettes and just ended up binding the inside of the holes. I used the oval tool in "Paint" to design and print my ovals then made a template from cardstock to trace the hole onto the instrument. Arnt Rian does them and had offered some advice on them in past posts. He used a shop made scratch stock and a chisel to cut the rosettes after he had already cut the hole in the top, using the edge of the hole to register the scratch stock. |
|
| Author: | Darrel Friesen [ Sat Dec 18, 2021 6:02 pm ] |
| Post subject: | Re: Oval Sound Hole and rosette |
Found the Mimf thread discussing it. https://www.mimf.com/phpbb/viewtopic.ph ... tte#p46150 |
|
| Author: | peter.coombe [ Sat Dec 18, 2021 6:08 pm ] |
| Post subject: | Re: Oval Sound Hole and rosette |
I have done lots (> 200) on mandolins. Has been documented here - http://petercoombe.com/Construction/carrving-the-top.htm http://petercoombe.com/Construction/soundhole-trim.htm |
|
| Author: | Darrel Friesen [ Sat Dec 18, 2021 6:58 pm ] |
| Post subject: | Re: Oval Sound Hole and rosette |
peter.coombe wrote: I have done lots (> 200) on mandolins. Has been documented here - http://petercoombe.com/Construction/carrving-the-top.htm http://petercoombe.com/Construction/soundhole-trim.htm Nice tutorial Peter. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|