| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Irish bouzooki truss rod slot http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10101&t=54173 |
Page 1 of 1 |
| Author: | Ernie Kleinman [ Thu May 27, 2021 10:02 am ] |
| Post subject: | Irish bouzooki truss rod slot |
My question , concerns a thin walnut neck which tapers from 34 mm at the nut to 44mm at the 12 th fret .Its a 600 mm scale . its an 8 string bouzooki. Reading up on the internet literature. electric guitar builders suggest a curve in the middle of the FB. Is this viable ?. or is a flat slot preferable ?. I have already cut a 10 mm slot for a single action truss rod. Which leaves abt a 1/2mm of clearance over the truss rod. The adjustment will be at the headstock. This will be a bolt on neck . TNX in advance |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|