| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Would you use these metal slats http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10101&t=52259 |
Page 1 of 1 |
| Author: | guitarradTJ [ Sun Aug 11, 2019 2:24 pm ] |
| Post subject: | Would you use these metal slats |
Hey guys, bought a used side bending jig that came with these slats. I'm bending a cutaway. Would you use these slats? They're a bit wavy. Would you get new ones... I'm ready to bend, don't really want to wait on shipping for another set... Thanks for any input!   Sent from my SM-G950U using Tapatalk |
|
| Author: | Barry Daniels [ Sun Aug 11, 2019 2:29 pm ] |
| Post subject: | Re: Would you use these metal slats |
Those look like LMII stainless steel slats. Spring steel is so much better. |
|
| Author: | Bri [ Sun Aug 11, 2019 2:41 pm ] |
| Post subject: | Re: Would you use these metal slats |
I straighten mine out and reuse them. No issues for me, just a bit of futzin’. B |
|
| Author: | guitarradTJ [ Sun Aug 11, 2019 2:50 pm ] |
| Post subject: | Re: Would you use these metal slats |
Bri wrote: I straighten mine out and reuse them. No issues for me, just a bit of futzin’. Do you get them completely flat again? Or are they a bit wavy?B Sent from my SM-G950U using Tapatalk |
|
| Author: | giltzow [ Sun Aug 11, 2019 5:05 pm ] |
| Post subject: | Re: Would you use these metal slats |
I use spring steel for my non- cutaway guitars and stainless steel for the cutaways. I press the stainless between two flat boards and clamp to straighten them. Still a bit of wave but comes out as I bend - Mike G |
|
| Author: | Bri [ Mon Aug 12, 2019 9:12 am ] |
| Post subject: | Re: Would you use these metal slats |
guitarradTJ wrote: Bri wrote: I straighten mine out and reuse them. No issues for me, just a bit of futzin’. Do you get them completely flat again? Or are they a bit wavy?B Sent from my SM-G950U using Tapatalk They are never perfectly flat after the first use. Once in the bender, the wrinkles are not noticeable. B |
|
| Author: | guitarradTJ [ Mon Aug 12, 2019 6:47 pm ] |
| Post subject: | Re: Would you use these metal slats |
Thanks guys, I put them in between 2 boards and closed them up. Sent from my SM-G950U using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|