| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Jet 10-20 Conveyer Belt Source? http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10101&t=52043 |
Page 1 of 1 |
| Author: | sdsollod [ Thu Jun 13, 2019 6:19 pm ] |
| Post subject: | Jet 10-20 Conveyer Belt Source? |
I finally need a new conveyer belt for my Jet 10-20. Any suggestions for a vendor? I suspect some may be better than others... |
|
| Author: | Ken Lewis [ Thu Jun 13, 2019 6:22 pm ] |
| Post subject: | Re: Jet 10-20 Conveyer Belt Source? |
Here's a good place. https://www.supergrit.com/ConveyorBelts |
|
| Author: | CarlD [ Thu Jun 13, 2019 8:42 pm ] |
| Post subject: | Re: Jet 10-20 Conveyer Belt Source? |
Here's another, https://2sand.com/feed-belt-for-jet-per ... -x-32-5-32. |
|
| Author: | Bri [ Thu Jun 13, 2019 9:35 pm ] |
| Post subject: | Re: Jet 10-20 Conveyer Belt Source? |
Try this; https://www.woodworkingshop.com/search. ... eyor+belts |
|
| Author: | James Orr [ Thu Jun 13, 2019 10:53 pm ] |
| Post subject: | Re: Jet 10-20 Conveyer Belt Source? |
I got mine through Highland Woodworking a few years ago. No complaints. |
|
| Author: | dofthesea [ Sat Jun 15, 2019 11:04 pm ] |
| Post subject: | Re: Jet 10-20 Conveyer Belt Source? |
On par with this question.... is there a better alternative then then the standard sand paper style conveyor belt? I need to get a new one for my 16-22 Jet Drum sander as well. |
|
| Author: | Bri [ Sun Jun 16, 2019 12:57 am ] |
| Post subject: | Re: Jet 10-20 Conveyer Belt Source? |
dofthesea wrote: On par with this question.... is there a better alternative then then the standard sand paper style conveyor belt? I need to get a new one for my 16-22 Jet Drum sander as well. http://accuramachinetools.com/replaceme ... 32-sa.html Not sure if its better but its costly. B |
|
| Author: | CarlD [ Sun Jun 16, 2019 11:20 am ] |
| Post subject: | Re: Jet 10-20 Conveyer Belt Source? |
I tried that kind when I first got my old 16-32. Soon went back to the sandpaper because the pieces seemed to slip more on the rubber. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|