Official Luthiers Forum!
http://mowrystrings.luthiersforum.com/forum/

saving the Gibson serial number
http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10101&t=51948		 Page 1 of 1
Author:  cablepuller1 [ Sat May 18, 2019 3:40 am ]
Post subject:  saving the Gibson serial number
hi

I'm thinking that I'm going to have to refinish this old Gibson (reluctantly due to experience)

the serial number is a concern as it's already very faint, I can get the numbers in the light.

what should I do to save them?ImageImage

Sent from my SM-G960F using Tapatalk
Author:  Hesh [ Sat May 18, 2019 4:45 am ]
Post subject:  Re: saving the Gibson serial number
Number punch sets that match what Gibson used in terms of size, style, etc and a bit of practice to get the uniformity right. Good thing you can still get the original number.
Author:  cablepuller1 [ Sat May 18, 2019 4:55 am ]
Post subject:  Re: saving the Gibson serial number
Hesh wrote:
Number punch sets that match what Gibson used in terms of size, style, etc and a bit of practice to get the uniformity right. Good thing you can still get the original number.
thanks Hesh, are there a particular set available for gibsons mate

Sent from my SM-G960F using Tapatalk
Author:  Hesh [ Sat May 18, 2019 5:21 am ]
Post subject:  Re: saving the Gibson serial number
You bet.

I don't think so. I know that Dave searched for years to find punches that matched perfectly and only found stuff at second hand sources like auctions and yard sales that comes close enough to use. We've rarely had to do this and I can only think of a few times in years.
Author:  B. Howard [ Sat May 18, 2019 5:51 am ]
Post subject:  Re: saving the Gibson serial number
Someone over at the MyLesPaul forums made a run of these stamps a few years ago. Don't know of a current source.

Often times these are full of sealer and lacquer, you may be surprised at how deep they are after removing the finish with some solvent.
Author:  cablepuller1 [ Sat May 18, 2019 6:00 am ]
Post subject:  Re: saving the Gibson serial number
B. Howard wrote:
Someone over at the MyLesPaul forums made a run of these stamps a few years ago. Don't know of a current source.

Often times these are full of sealer and lacquer, you may be surprised at how deep they are after removing the finish with some solvent.
oh didn't think about that, will have a closer look, thanks

Sent from my SM-G960F using Tapatalk
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/