| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Two things: http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10101&t=50763 |
Page 1 of 1 |
| Author: | Ruby50 [ Mon Jun 25, 2018 9:29 am ] |
| Post subject: | Two things: |
First - I found this on my bench - does anyone recognize it? The shaft has a flat spot its whole length Second - after 5 fretboards, I just notices a line scored down the length of the blade of my StewMac fret saw. It is just a little deeper than the fret barbs and works great at letting you know you are deep enough. Is this intentional? Do others have this on their saws? Ed |
|
| Author: | SteveG [ Mon Jun 25, 2018 11:33 am ] |
| Post subject: | Re: Two things: |
Screw extractor? https://www.familyhandyman.com/tools/ex ... /view-all/ |
|
| Author: | Bryan Bear [ Mon Jun 25, 2018 12:35 pm ] |
| Post subject: | Re: Two things: |
SteveG wrote: The threads go the wrong way. I can't wait to find out what it is. I know one of us must know. . . |
|
| Author: | bcombs510 [ Mon Jun 25, 2018 12:38 pm ] |
| Post subject: | Re: Two things: |
Is the allen key there for scale or does it go with it somehow? |
|
| Author: | CarlD [ Mon Jun 25, 2018 1:25 pm ] |
| Post subject: | Re: Two things: |
It looks like the threaded center for a "self feed" bit which could be turned around when the threads get too worn to pull the bit into the board. I used to use them for electrical and plumbing chases in log homes. |
|
| Author: | Bri [ Mon Jun 25, 2018 1:56 pm ] |
| Post subject: | Re: Two things: |
The line on the saw is where the harder steel for the teeth is welded. Is the threaded bit a screw centre for a lathe? B |
|
| Author: | Michaeldc [ Mon Jun 25, 2018 2:28 pm ] |
| Post subject: | Re: Two things: |
I'm gonna go with a replacement feed screw for an auger. |
|
| Author: | CarlD [ Mon Jun 25, 2018 3:10 pm ] |
| Post subject: | Re: Two things: |
Here's a pic of a self feed bit. Milwaukee Elect. |
|
| Author: | Woodie G [ Mon Jun 25, 2018 4:39 pm ] |
| Post subject: | Re: Two things: |
Or just a screw starter... |
|
| Author: | Ruby50 [ Mon Jun 25, 2018 9:17 pm ] |
| Post subject: | Re: Two things: |
My daughter gave me a giant Milwaukee Forstner type bit a couple of months ago, just like the one pictured only bigger - she used it in an art project a few years ago and was cleaning house. That's it. I was looking it over and left the bag on the bench. Also, this particular saw does not have a different steel at the edge - the saw plate is all the same steel. Anybody else on the scored line on the saw?? Thanks Ed |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|