I did one recently and I am pretty sure I cut through the abalone.
.
Sent from my iPhone using Tapatalk
| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| overhang on bound fretboard http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10101&t=50695 |
Page 1 of 1 |
| Author: | Ruby50 [ Fri Jun 01, 2018 6:57 am ] |
| Post subject: | overhang on bound fretboard |
I am binding a fretboard and have a question On an ebony board, I am contemplating a .06 abalone strip down either edge, with about a .06 ebony strip outside of that. That leaves about .12 outboard of the actual ebony board down either edge. I am thinking that the frets will not like seating in the abalone, so the cut off tang will have to span the entire .12 of the combined ebony/abalone edging. Is this too much for no tang?? Something like this, but with different materials and the fret slot not continuing through the "white" part Ed |
|
| Author: | Woodie G [ Fri Jun 01, 2018 8:20 am ] |
| Post subject: | Re: overhang on bound fretboard |
My experience here is that for 18% nickel silver wire, up to 0.188" of crown free of the tang is tolerable with good technique (i.e., careful pre-bending of crown). If there is an option to use either EVO or stainless, you can get some additional resistance to distortion should an edge get caught, etc. All this supposes the frets are glued in to minimize the opportunity for grime and perspiration to accumulate under the fret crown. |
|
| Author: | arie [ Fri Jun 01, 2018 10:36 am ] |
| Post subject: | Re: overhang on bound fretboard |
fwiw, for me, it's crown width max. anything more seems to require "aids" in order to minimize risk. if you need more, remove whatever barbs are going through the shell and run the slot right into the ebony. |
|
| Author: | Brad Goodman [ Fri Jun 01, 2018 1:36 pm ] |
| Post subject: | Re: overhang on bound fretboard |
I did one recently and I am pretty sure I cut through the abalone. . Sent from my iPhone using Tapatalk |
|
| Author: | Joe Beaver [ Fri Jun 01, 2018 1:58 pm ] |
| Post subject: | Re: overhang on bound fretboard |
I wouldn't expect any problem with cutting thru the shell and putting a tang into it. I would do it the same way you did in the photo, route a ledge on the board, install shell, cut the fret slots through the shell and then bind. That will leave you with .06" of no tang, perfect!!! |
|
| Author: | bluescreek [ Fri Jun 01, 2018 4:20 pm ] |
| Post subject: | Re: overhang on bound fretboard |
I do these on a regular basis I will use poly when I bind the board then set about a.030 gap at the fret slot. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|