| Official Luthiers Forum! http://mowrystrings.luthiersforum.com/forum/ |
|
| Anyone had trouble with an Accu link V belt? http://mowrystrings.luthiersforum.com/forum/viewtopic.php?f=10101&t=49906 |
Page 1 of 1 |
| Author: | Pmaj7 [ Sat Nov 04, 2017 8:08 pm ] |
| Post subject: | Anyone had trouble with an Accu link V belt? |
Just got one from Harbor Freight, is half-inch, but it measures .530. My machined motor pulley is .500 and it does not want to stay in there no matter how tight I get it as it is very rigid. These are made in eec. I guess they used to be made in the US or Italy. Am I missing something? I'm putting it in a Delta X5 14-inch bandsaw. Interestingly the replacement part I found on the internet says 3/8" but the outside of the pulley is definitely 1/2" and the V belt that was in there measures at .470. |
|
| Author: | klooker [ Sun Nov 05, 2017 8:47 am ] |
| Post subject: | Re: Anyone had trouble with an Accu link V belt? |
I get my belts from either the hardware store (I'm lucky to have a real one) or the auto parts store. The belt on my 90's Delta is nothing special or exotic. |
|
| Author: | Clay S. [ Sun Nov 05, 2017 8:49 am ] |
| Post subject: | Re: Anyone had trouble with an Accu link V belt? |
"My machined motor pulley is .500 and it does not want to stay in there no matter how tight I get it as it is very rigid." You may want to get a bigger pulley or smaller belt. Making belts too tight is hard on the bearings. |
|
| Author: | ernie [ Sun Nov 05, 2017 9:31 am ] |
| Post subject: | Re: Anyone had trouble with an Accu link V belt? |
I tried one on a s-45 mini- max did not like the belt , got mine at Hf . U can get quality belts from wal mart online or local auto parts store. |
|
| Author: | toddb [ Sun Nov 05, 2017 12:48 pm ] |
| Post subject: | Re: Anyone had trouble with an Accu link V belt? |
Matthias Wandel posted something on his Woodgears site about this. http://woodgears.ca/delta_saw/linkbelt.html |
|
| Author: | Barry Daniels [ Sun Nov 05, 2017 1:51 pm ] |
| Post subject: | Re: Anyone had trouble with an Accu link V belt? |
I would suspect your HF belt is not a real Accu Link, but a poorly made copy. |
|
| Author: | J De Rocher [ Sun Nov 05, 2017 2:40 pm ] |
| Post subject: | Re: Anyone had trouble with an Accu link V belt? |
I put a link belt on my 14" Delta a little over four years ago and it worked fine from the get go. The belt I got is a 1/2" Fenner Power Twist belt which looks like the same design as the Accu link belt. The Power Twist belt is plenty flexible. Maybe that makes a difference in performance? The other thing is that the widths of the pulleys on my Delta are wider if I understand your post correctly. They are 3/4" wide on the outside and the inside width of the groove is 1/2". Maybe that contributes to the problem? |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|