That's a sharp looking guitar! I'm impressed by the fact that you routed the inlay recesses so that the midribs of the feather inlays are intact fretboard wood and not filler.

Nicely done. How did you like working with the Pau Ferro?

I have no idea where/who to approach to get laser work done in the spirit of what was done on this fingerboard. Any chance that OP can share information on the laser work?

Thanks!

Aside from not having access to a laser, not having any cad/cam training, and little interest in climbing the learning curve, no, nothing specific comes to mind....As to learning all the above, I think I need to pass on it. Too much else to do before what amount to luxury work gets done. But I'd sure like to be able to hire out some work.

I'd love to learn how to contact someone who could take an image I have on paper and turn it into a laser-cut inlay and a laser-cut cavity in the wood I'm sending them.

Again, thanks very much.

Bruno, what did you use for the inlays, wood? ...if so, what kind of wood is it?